General safety technical requirements for the hott

2022-08-12
  • Detail

General technical requirements for vehicle safety

1. Strictly abide by the road traffic safety law of the people's Republic of China

2. Car drivers must undergo professional training, pass the examination of relevant departments, and be licensed before driving independently. In addition to holding a trainee driver's license, the trainee driver should have a formal driver to drive with the vehicle. Driving without a license is strictly prohibited

3. Drivers are strictly prohibited from drinking alcohol before driving, smoking, eating food and chatting during driving. No excess passengers are allowed in the cab

4. Carefully check all parts of the vehicle before driving:

(1) whether the steering device is sensitive and reliable

(2) tire pressure, nuts, whether there is burst and looseness are also difficult to enter the domestic market

(3) the brake and clutch should be sensitive and reliable, and the gear lever should be placed in the "neutral" position

(4) whether the horn and instrument are sensitive and accurate

(5) whether the fuel and lubricating oil are sufficient

(6) whether the door is tight, and whether the lighting and battery electrohydraulic meet the requirements

(7) whether the cooling water is sufficient

(8) whether the engine, transmission part and frame are normal

drive only after confirmation, and all vehicles are strictly forbidden to leave with diseases

5. The car should sound the horn, slow down and keep right when starting, entering and leaving the factory, workshop gate, reversing, turning around, turning and crossing the intersection; When the sample reaches the specified deformation, the intersection should be "slow, look, and pass"; When passing cars, we should be courteous and "give way first, slow down first and stop first"

6. When driving in the factory, the speed shall not exceed 10 km/h; The speed of entering and leaving the gate, workshop and warehouse shall not be greater than 5 km/h

7. When driving in the construction site and workshop, pay close attention to the surrounding environment and personnel movements, sound the horn, drive slowly at low speed, and be ready to stop at any time

8. For long-distance driving, you must bring enough repair tools, materials and spare parts with you before departure

9. When starting the engine with a crank, the thumb must be out, and the five fingers must be close together. It is not allowed to hold the handle at the mouth of the tiger. It is necessary to prevent the crank from hitting back or slipping off and hurting people

10. Do not preheat carburetor, oil pipe and oil tank with open fire

11. The engine should be shut down during lubrication, inspection and repair work under the vehicle. Do not touch the high-voltage wire connector or fan with your hands when the engine is rotating

12. When starting the engine for the first time, it is necessary to turn it slowly for one or two minutes, and do not suddenly increase the speed

13. It is forbidden to step down the clutch, turn off the switch or put the gear lever in "neutral" when going downhill or at high speed, so as to avoid sudden acceleration of the engine and serious damage to the parts

14. Do not shift without stepping on the clutch, and do not put your foot on the clutch pedal when the car is driving

15. During driving, drivers should pay attention to road conditions and traffic signs. On the one hand, you should also pay attention to the instructions of the instrument, and listen to the sound of all parts of the vehicle. If there is any abnormality, you should stop and check, and do not drive reluctantly

16. When the engine temperature is too high due to serious water shortage in the water tank on the way, the engine should be shut down immediately, and cold water should be added after the engine cools down

17. When stopping on the way, check the connection and fastening of driving, steering, braking and engine parts, and remove stones and other objects embedded on the tire surface. Before starting, you should also carefully check the surrounding conditions around the vehicle to prevent someone from entering the bottom of the vehicle

18. When driving on muddy and frozen roads, it is best to install anti-skid chains and drive at a low speed where necessary. Do not make quick turns or emergency braking

19. When passing through dangerous areas or narrow temporary bridges, stop first and check to confirm that it can pass before running. It is best for someone with driving experience to command the car to slow down with gestures in front of the car 10 ~ 15 meters away, and be prepared to stop at any time

20. It is forbidden to drag the vehicle without bad braking, steering failure and unmanned operation with chain or steel wire rope. The driving speed of the trailer should not be too fast

2 is still the query method of the main stream. 1. Pull the handbrake when parking. Try to avoid parking on the ramp. When it is necessary to stop, block the tire with triangle wood or stones to prevent slipping

22. Drivers are not allowed to drive without authorization. Learners are only allowed to drive on flat roads and places with few pedestrians, and under the supervision of drivers. The instructor shall be responsible for any accident caused by the learner's manipulation

23. New cars and overhauled cars must be operated during the running in period as required. During the running in period, it is not allowed to remove the speed limiter. Generally, the speed shall not exceed 30 km, and the road surface shall be flat and good. The load capacity shall not exceed 75% of the rated value, and it is not allowed to tow a trailer. After the running in period, maintain and replace the lubricating oil as required

24. Maintain and clean after parking. If the antifreeze is not used in winter, the cooling water must be drained. After draining, it should be started several times in order to drain the accumulated water. During seasonal replacement, corresponding maintenance shall be carried out, the lubricating oil shall be replaced, and the specific gravity of the regulator and the battery shall be adjusted

25. Vehicles loaded with dangerous goods shall not be parked at will, and special personnel shall be assigned to guard them when parked midway

Copyright © 2011 JIN SHI